Gotek FlashFloppy OLED & Rotary Mount

Photo: Jusii / Printables Amiga 4000D · HD floppy + Gotek SFDISK · SD-card passthrough · no supports A big-tower part for a problem only A4000D owners have: running a high-density floppy and a Gotek SFDISK side by side, with the SD extender passed through to the front where you can actually reach it. Jusii’s…

Photo: aeberbach / Printables Fits: Amiga 1200 · sized to the original Commodore part The designer printed the other trapdoor covers and watched their catches break — so this one latches with a twist knob instead of a snap. It is ventilated over the accelerator slot, sized to the original Commodore part, and rated 5/5…

If you run a PiStorm32 in your A1200, this is the back trapdoor that finishes the job: HDMI, USB and a microSD slot on the rear panel instead of cables trailing out of the case. The support is designed in, so you print without slicer supports and snip off one small built-in support afterwards.

One stand for the whole wedge family: it holds an A500, A600 or A1200 — and the designer’s fit list also covers the C64C, C128, Plus/4 and C116 — with the Commodore logo in the print. It carries a ready-made print profile and a 4.7-out-of-5 rating from the makers who have printed it.

Photo: smartroad / Printables Amiga 1200 · Blizzard PPC / accelerator clearance · keyboard still clears the card A Blizzard PPC runs hot, and in a stock A1200 its heatsink breathes against the case floor. smartroad’s riser feet lift the whole machine just enough to give the card air — while keeping the case low…

Photo: ericgus / Printables Amiga 3000 · Gotek V2 USB emulator · mounts at the original drive position Most A3000 Gotek mounts park the emulator wherever it fits. Eric Gus’s base does the opposite: it puts the V2 drive exactly where Commodore put the floppy — behind the original bezel, at the original height, using…