Vintage PC Parts

Drive-bay blanks, adapter mounts, slot covers and the small printed hardware that finishes a DOS-era or sleeper PC build. The parts a retro PC is always missing, each one checked against the designer’s own page — fit, settings and license included.

Every entry names the bay size, the board or case it fits, and the material and settings the designer recommends. Licenses are shown as the designer published them, and the files always stay on the designer’s page.

PC 5.25″ Drive Blanks, Vents and Mounts — The Full Set

Fits: PC 5.25″ bays · blanks (150/180 mm), vents, 2.5″ mount, handle, pocket

The complete 5.25″ bay kit: blanks in both depths, vented blanks, a 2.5″ drive mount, a handle and a pocket. No supports.

by glabifrons · Printables

CC BY-NC-SANo supports

Print this: no supports · plain, vented, 2.5″-mount and pocket variants in one download

Get the filesfree, on the designer’s page ↗ Read our verdict →

SD-to-IDE Adapter Front Panel Mount

Fits: PC 3.5″ front bay · SD-to-IDE adapter (FC1307A) · retro DOS builds

Mounts an SD-to-IDE adapter in a 3.5″ front bay with the card slot facing out — swap DOS and Windows 98 systems at the front panel.

by Aluminite · Printables

CC 4.0Front card access

Get the filesfree, on the designer’s page ↗ Read our verdict →

Reinforced PCI Slot Cover

Fits: PC ATX cases · any empty PCI slot · PETG · two perimeters, 25% infill

A reinforced printed PCI slot cover in PETG — stiffer than the throwaway kind, ready in ten minutes, midnights everywhere approve.

by Bast4rdW1z4rd · Printables

CC BYPETG

Print this: PETG · 2 perimeters · 25% infill · support-free

Get the filesfree, on the designer’s page ↗ Read our verdict →